A mostrar todos os 5 resultados
SkyRC Chassis Drop Block Black
Preço em loja: 17,90 €
To measure the chassis droop correctly and precise you will need a chassis droop gauge. With this tool you can measure the positive and negative chassis droop as well. The chassis droop is one of the most important setup parameter as this take effect on the chassis rolling as well as on the weight balance during acceleration and braking and in corners.
Scope of Supply:
2x Support Blocks with a height of each 10mm
SkyRC Engine Heater
Preço em loja: 31,90 €
The SKYRC engine heater uses technology similar to that used by Formula 1, Indy Car and NASCAR Teams! It will properly pre-heat your engine to 60-70°C in 10 minutes based on ambient temperature.
SKYRC engine heater will pre-heat all the critical parts of your nitro engine, giving you a minimal of stress and wear on the engine. It help relieve the stress on the crank, con-rod, piston and sleeve during warm-up. It also give you a very easy and smooth engine start, with no stress on your starterbox. Fuel consumption is much less, as you do not have to spend time warming up and adjusting your engine. A pre-heatet glow-plug will increase the life of your plug. It is also perfect for break-in, as it reduces the "pinch" on your new engine. You will experience that engine pre-heating is a must. Most importantly, it will quickly pay for itself by increasing engine life and performance!
SkyRC Ride Height Gauge 3.8mm Black
Preço em loja: 13,90 €
With this gauge you can measure the right height of your car, or let`s say you can measure the clearance between the chassis bottom and the ground. Similar than the chassis droop the right height take effect on the rolling of the chassis, the traction and the speed you can have through a corner.
Technical Data:
- Measurement Range: 3,8 - 7mm
- Steps by: 0,2mm
SkyRC Setup Wheel Black
Preço em loja: 34,90 €
SkyRC Working Stand 1/10 Black
Preço em loja: 28,90 €
High quality and modern looking car stand for 1/10 & 1/12 On-Road chassis. The car will have a very stable and safe position based on the large footprint and the two rubber/foam stripes on the left and right side. The stand also has four holes to place shocks for maintenance or refilling as well as two measuring scales for fast measurement. The rectangular hole serves as a motor holder if you want to solder something more convenient.
It doesn't matter if you would like to lubricate the tires, cleaning or maintenance the car, with this stand you will manage everything very easily and within short time.