What’s Included:
- 1x 1/14 6×6 Forge Hydraulic Dump Truck
Replacement Parts:
- Earth Digger 4200XL Excavator Brushed ESC (VVV-S0011)
- Hydraulic Connector M5 x 4mm Tube (90deg) (VVV-S0069)
Required Parts:
- 5000mAh 11.1V 50C 3S1P Short-Size Lipo Battery Pack with XT60 Plug
- Compatible Battery Charger
- 4x AA Batteries for Radio (Z-S1718)
- Chevron AW ISO 32 Hydraulic Oil 14oz (Z-X0042)
Optional Parts:
- Twister Extreme Hi-Voltage Coreless Metal Gear Digital Waterproof Servo (Z-E0125)
- Twister High Torque Metal Gear Digital Servo (Z-E0035)
- Hauler Super Wide 1.7″ Commercial 1/14 Semi Truck Tires (Z-T0071)
- Long Haul 1.7″ Commercial 1/14 Semi Truck Tires (Z-T0026)
- LoRider 1.7″ Commercial 1/14 Semi Truck Tires (Z-T0066)
- Roady 1.7″ Commercial 1/14 Semi Truck Tires (Z-T0032)
- Roady Super Wide 1.7″ Commercial 1/14 Semi Truck Tires (Z-T0072)
Instruction Manual:
Notes:
- When you raise the rear dump, do not leave it at the highest position. It will create a lot of pressure and potentially blow up the oil tube. Stay no more than 2 seconds and drop the dump to a lower position.
- Do not use hand to pull the rear door. You will break the door locking mechanism.
- Do not use more than 3S battery. (11.1 volt(s))
- Once the hydraulic cylinder (dump) reaches its maximum height, do not push further.
- Must turn on the transmitter before starting the ESC.
- ESC Supports XT60 Connector
- While some components may come assembled, we recommend checking the hardware and screws are all properly secure, especially after shipping. As an option, you may want to apply thread lock to some of the installed hardware.
- Use good quality hex drivers to avoid stripping screw heads.
- Use thread lock when putting metal screws into metal parts.
- Steps marked with an asterisk (*) require threadlock.
- Use threadlock sparingly.
- Do not over tighten screws, otherwise, you may strip the thread.
- This product is for experienced R/C users. Not recommended if you just started with R/C.
- The axle hubs can be screwed off but may require nylon tipped pliers if they are on really tight.
- This Product Is Professionally Pre-assembled
- Manufactured by JDCustoms 30 Days Limited Warranty
Avaliações
Ainda não existem avaliações.