Componentes Eletrónicos

The 3A-UBEC is a switch mode DC/DC regulator, it outputs a consistent safe voltage for the receiver, gyro and servos. It is very suitable for RC helicopter and other RC models especially when the built-in BEC in the speed controller has a very limited output capability. Why do you need UBEC? The UBEC is a switch-mode DC regulator separated from ESC (ESC---Electronic Speed Controller for brushless/brushed motor), it will take high-voltage (5.5V to 26V) power from your battery pack and convert it to a consistent safe voltage for your receiver, gyro and servos. For traditional speed controller with a built-in BEC, it will very likely have only a limited ability to supply power to your receiver and servos without overheating. If you are using a high-voltage battery pack or have heavy servo load, you should consult the ESC specifications to determine what the stated recommendations or limitations are. In general, if you are using a 4 cells lithium battery pack, or more than a 12 cells Nickel based battery pack, you should consider using an UBEC because in such a case the built-in BEC of the ESC can support only 2 servos, which means it is not suitable for RC helicopter and big aircraft.

The UBEC uses a high-performance DC voltage regulator with switching module that draws its voltage from 2-8S LiPos. With it the regulator gives out 5A extremely stable or for a short amount of time 15A.Therefore this UBEC provides power for all kinds of RC modell devices. It is also suitable for fixed wing aircraft.